The pipe bender is one of the bending equipment and is a special tool for bending the copper tube. It is suitable for the use of aluminum-plastic pipe, copper pipe and other pipelines, making the pipe bending neat, smooth and fast. In order to facilitate everyone to understand the pipe bender, the following small series will tell you about the use of the pipe bender, maintenance procedures and precautions.
　　 Pipe bender use
Firstly, the bending part of the copper pipe is annealed, the copper pipe is inserted into the groove between the roller and the guide wheel, and the copper pipe is fixed by the fastening screw, and then the movable lever is rotated clockwise, and the copper pipe is guided by the roller and the guide wheel. The groove is bent into the desired shape. The guide wheels with different radii can be replaced to bend the pipes with different bending radii, but the bending radius of the copper pipe should not be less than three times the diameter of the copper pipe, otherwise the inner cavity of the curved portion of the copper pipe is easily deformed.
　　 Pipe bender repair steps and precautions
First of all, when repairing the bender, you need to carefully check the surroundings of the workplace to clean up all the debris that may hinder work and traffic. Oil can not be dripped on the ground to prevent people from slipping, and the workpieces are stacked neatly and securely to prevent collapse and injury.
Check the lubrication part of the machine. If it is in the state of lack of oil and no oil, the oil should be added to a sufficient amount. When commissioning an empty car, check if the pipe bender is operating normally and the electrical switch is intact and sensitive. After all the work is normal, the processing operation is performed.
It is also necessary to check the guard on the bender to see if it is in good condition. If it is installed, it cannot be driven. The intermediate frequency bender needs to have a stable voltage and good grounding and electrical insulation.
When operating the pipe bender, no one is allowed to be within the bend range of the pipe fittings, and a protective warning sign is set in advance. When tilting the pipe fittings, the operator should stand firm to prevent the club from slipping and causing personal injury.
It is necessary to cooperate closely when the two people are working on the workpiece at the same time, and the coordination needs to be consistent. And assign a special person to operate the switch in advance. When operating, you are not allowed to jok with others to prevent malfunctions. The operator must not leave without the bender operating.
In addition, when you are correcting the fittings, you need to check and pay careful attention to the safety of the surrounding. Use the steamed buns to dip into the water first; for a few minutes, prevent the handle from being injured. Do not wear gloves when handling pipe fittings.
I read the above-mentioned Xiaobian for everyone to introduce the use of the bender, maintenance procedures and precautions, I believe that everyone now has a certain understanding of how to use the bender and how to repair when encountering problems. There are various types of pipe benders, one of which refers to the tool used for the electrician wiring pipe, and the bent pipe for the electric wire pipe, which belongs to a coil spring shape tool.
The heating element give off the far infrared energy waves directly, heating the whole environment, people and objects. The electric infrared heating panels can be built with high thermal insulation material, so that the heat can be stored and still release within a certain time after the power outage. It is much more safe and efficient. This is a new concept of healthy and comfortable heating way.
Panel Heater With Thermostat,Infrared Electric Panel,Panel Convector Heater,Electric Panel Heaters
Shandong Dexiang Electrical Technology Co.,Ltd , https://www.infraredroomheater.com