Pumps also known as drum oil pump, can transport acid, alkali, salt, oil, beverages and other media, widely used in chemical, petrochemical, fine chemicals, chemical dyes, environmental protection, water treatment, medicine, food and other departments. At the same time for small and medium sized oil fields, oil depots, gas stations, farm stations, enterprises and institutions, the fleet, vehicles, ships and other transportation of gasoline, kerosene, diesel, the ideal tool for light oil. Note on the use of barrel pump safety and safety instructions (A) Note the use of barrel pump 1, the provisions of the use of voltage: line voltage does not exceed the voltage on the pump nameplate ± 10% before use. 2, How to equip: After unpacking, assemble according to the sketch of the structure, connect the motor (1) and connect the mobile phone (2) with the pump body and the motor as a whole (3) Parts in good condition to boot. 4, the pump should not be empty running, use, the suction is completed, that is, stop the pump, otherwise it will speed up impeller seals bearing wear and tear. May also wear pump tube, the pump motor idling speed of up to 10000 rev / min. 5, timely exchange of brushes, brush wear will not be able to use, must be promptly replaced (2 brush at the same time exchange) Otherwise it will brush and commutator bad contact caused by ring loss, damage commutator, severe punishment will be Burned armature. 6, in the following circumstances shall not be used in the course of such as the discovery of insulation damage, the power cord cable jacket rupture, plug or socket cracking or poor contact, and intermittent operation, severe punishment sparks and other failures, the motor shell operation, Should be repaired immediately. Do not use before repair. 7, to prevent overload, when used in case of unusual speed or lower speed, should stop down Check whether there is debris clutter impeller or motor failure, pumping pump brake must therefore immediately cut off the power to prevent the card dead burn. 8, to use the tools to cherish, all pumping pump to be careful to avoid being hit. (B) barrel pump safety instructions 1, in addition to comply with this note strictly GB3883.1-83 "hand-held power tools safety management, inspection, maintenance of technical regulations," the relevant provisions. 2, the product within the voltage range of ± 10% before use. 3, to avoid the electric level and water, oil in the installation of electric place, all of this pump, do not damage the power level, and to avoid oil, water and electrical switches and other electrical parts of the contact. 4, to prevent a sudden start, the power switch is turned on before the "off" (that is, press into) state. 5, do not abuse the power cord, the power cord may not be any length or exchange. Can not pull the power cord scraping, cutting and rolling bad phenomenon. 6, the pump is Flameproof, when replacing the brush or repair, pay special attention to the explosion-proof surface of the explosion-proof parts can not make it damage the hair. When repairing or replacing the brush, please turn on the motor to clean the inner cavity toner and oil rot. 7, the proper use of hand, the pump power cord without a plug at one end, the user selects the right plug, there are two special needs attention: A, as in the explosive and flammable with plugs and sockets must comply with the explosion-proof procedures Plugs and sockets, set in the normal area away from explosive and flammable venues, available 220V5A three-pin plugs, one of the long legs for the ground. B, no matter what kind of plug should be reliably grounded, the power cord at one end of the yellow-green wire for the ground wire, when properly connected, should check the pump metal case and the contact between the legs are electrically connected, which is resistance should not be greater than 1 European mother. 8, the banned place: In special environments such as wet, snow and corrosive gases can not be used. Asia Fluid Network () Editor: Huang Nengwen, QQ:
Guangzhou Jointair Co., Ltd. , https://www.jointair.cn